Front tubular chassis bits follow the usual excessively complex MFH approach.
Progress was slow but steady. Making sure every little 0.5 mm socket is drilled out is critical.
The main flaw is the rack, which should have gone in earlier, is bent and the mounting pin i not quite entered into the left side socket.
Front wheels are test-fitted and it all looks nice and square.
Rear suspension and brakes also went on in order to get it sitting on all four as quickly as possible.
The chassis is essentially complete and sits nice and square. The front clip fits nicely but some work will be needed to get the engine lid to sit on it properly. Stay tuned!
No comments:
Post a Comment